top of page

ADJUST-A-BODY WITH TOGGLE

Post Types:

Metal

Fitting Types:

Tensioning, Swaging

Exposed, swaged, tensioning, face-of-the-post-mounted fitting for use on level runs only. This fitting is ONLY available for 1/8” diameter 1x19 stainless steel cable.


  • It can be used with any fitting on the opposite end of the run.

  • The Toggle portion of the fitting is secured into a pre-drilled hole in the end post. No tapping is required!

  • The cable is retained within the body portion of the fitting by a ferrule swaged onto the end of the cable.

  • Lock Nut is installed onto the Toggle first, followed by the body, secured onto the Toggle, creating tension on the cable.

  • Once sufficient tension is achieved, the Lock Nut is secured against the body's end to prevent the fitting from loosening.

  • Use of this fitting requires an appropriately sized ferrule that is swaged onto the cable, which must be purchased separately


We do not recommend installing this fitting in pitched applications because it would require drilling all of the holes in the end post at an angle. While this is possible with special fixtures, if it is not done correctly the end result would be visually unacceptable. Note: A minimum hole diameter of 5/16" and a minimum post thickness of 1/4" is required.


CABLE DIAMETER

PART NO.

1/8"

CH-A-J6-T2-4


bottom of page