top of page

PUSH-LOCK

Post Types:

Wood, Metal

Fitting Types:

Swageless

The Push-Lock® is a concealed, swageless, non-tensioning, through-the-post-mounted fitting that is suitable for use on level runs only, and is available for 1/8” and 3/16” diameter 1×19 stainless steel cable.


The Push-Lock® must be used with a tensioning fitting on the opposite end of the run. This fitting is installed into a pre-drilled hole in the end post. Using the Push-Lock® fitting on level runs requires that a minimum of 1-1/2” of clearance exists on the back side of the end post (to install the fitting through the back side of the post). It is also recommended that a stainless steel flat washer be installed between the shoulder of the fitting and the mating surface of the wood post. The cable attaches to the fitting via our Push-Lock® locking wedge system which requires no special tools.


This fitting is made to look similar to the Invisiware® Receiver from the exterior of the post, so it is recommended to use a Receiver with stud on the opposite end whenever practical to maintain a consistent look.

1/8" CABLE PART NO.

3/16" CABLE PART NO.

FRAME "F"

FRAME "R"

FRAME "P"

"L" LENGTH

CH-PL-4-12

CH-PL-6-12

1-1/2"

1-1/2"

1-1/4"

1.562"

CH-PL-6-2.030

CH-PL-6-2.030

2"

2"

1-1/2"

2.030"

CH-PL-4-3.030

CH-PL-6-3.030

3"

3"

NA

3.030"

CH-PL-4

CH-PL-6

4" x 4"

NA

NA

1.562"


bottom of page