top of page

PUSH-LOCK TENSIONER WITH TOGGLE

Post Types:

Metal

Fitting Types:

Tensioning, Swageless

Exposed, swageless, tensioning, face-of-the-post-mounted fitting suitable for use on level runs and is only available for 1/8” diameter 1x19 stainless steel cable.


  • It can be used with any fitting on the opposite end of the run.

  • Consists of two separate pieces: the Toggle and the Push-Lock® tensioning body. The toggle is installed into a pre-drilled hole in the end post. No tapping is required!

  • The cable attaches to the fitting via our Push-Lock® locking wedge system which requires no special tools.

  • The body threads onto the other end of the Toggle, connecting the two pieces.

  • Tension is created by securing the post-side segment of the body onto the toggle side while preventing the cable-side segment of the body from turning.


We do not recommend installing this fitting in pitched applications because it would require drilling all of the holes in the end post at an angle. While this is possible with special fixtures, if it is not done correctly the end result would be visually unacceptable. Note: A minimum hole diameter of 5/16" and a minimum post thickness of 1/4" is required.


CABLE DIAMETER

PART NO.

1/8"

CH-PL-CT-4


bottom of page