top of page

PUSH-LOCK TOGGLE

Post Types:

Metal

Fitting Types:

Swageless, Non-Tensioning

Exposed, swageless, non-tensioning, face-of-the-post-mounted fitting suitable for use on level runs and is only available for 1/8” diameter 1x19 stainless steel cable.

  • It can be used with any fitting on the opposite end of the run.

  • The toggle is installed into a pre-drilled hole in the end post. No tapping is required!

  • The cable attaches to the fitting via our Push-Lock® locking wedge system which requires no special tools.

  • This is a non-tensioning fitting. Fitting on the opposite end of the cable run must be a tensioning fitting.


We do not recommend installing this fitting in pitched applications because it would require drilling all of the holes in the end post at an angle. While this is possible with special fixtures, if it is not done correctly the end result would be visually unacceptable. Note: A minimum hole diameter of 5/16" and a minimum post thickness of 1/4" is required.


CABLE DIAMETER

PART NO.

1/8"

CH-PL-CNT-4


bottom of page